Glossary entry (derived from question below)
English term or phrase:
teach mode
Bulgarian translation:
режим на обучение (Teach режим)
May 27, 2009 15:23
14 yrs ago
English term
teach mode
GBK
English to Bulgarian
Tech/Engineering
Automation & Robotics
Definition from
RobotWorx:
The control state that allows the generation and storage of positional data points affected by moving the robot arm through a path of intended motions.
Example sentences:
The prototype medical robot developed (Fig. 1) is based on a CRS industrial robot with six degrees of freedom, a force sensor, a teach mode permitting manual learning of a “freehand” scan, and a replay mode of the manually taught path. (Evaluation of a Robot’s Performance for Medical 3D-Ultrasound Imaging)
This procedure is called program touch-up and is normally carried out in the teach mode of operation. (OSHA technical manual)
An application of robots where teach mode is indispensable is spray painting. (International Journal of Advanced Robotic Systems)
Proposed translations
(Bulgarian)
| 5 +2 | режим на обучение (Teach режим) |
Elena Marinova
|
Change log
May 27, 2009 15:12: changed "Kudoz queue" from "In queue" to "Public"
May 27, 2009 15:23: Enrique Cavalitto changed "Stage" from "Preparation" to "Submission"
May 30, 2009 15:54: changed "Stage" from "Submission" to "Completion"
Proposed translations
+2
5 hrs
Elena Marinova
Bulgaria
Bulgaria
Bulgaria
Your technical support
Native in: Bulgarian
Works in: English to Bulgarian, Bulgarian to English
Related KudoZ points
:
4
Selected
режим на обучение (Teach режим)
Definition from
own experience or research:
Това е режим, в който програмата за обработка се въвежда като се задава преместване от точка до точка на CNC осите в ръчен режим и след това извършеното преместване. при натискане на бутон за Teach режим (обикновено TEACH IN), се запомня като изречение от програмата. Използува се в роботизираните системи и машините със CNC управление.
Example sentences:
С подрежима на работа "Teach in" могат да се запаметяват стойности за позицията на осите директно в ново детайл-програмно изречение. (Siemens, SINUMERIK 802S/C base line)
4 KudoZ points awarded for this answer.
Discussion